The nut size of the Dodge RAM is 11/16th. This is mainly for the 12th point of the 1998 model of the 1500 from wheel.
Begin by removing the tire and wheel from your 2002 Dodge. Remove the end of the axle. Remove the wheel bearing nuts. Remove the wheel bearing. Reverse the process to install your new wheel bearing.
Yes.
The front bearings on Dodge Rams after 1998 are all sealed and non serviceable. If you have an older Ram with serviceable bearing, every 50000
More than likely you have a defective left front wheel bearing. Inspect the bearing and also inspect the bearing on the right front. Inspect your brake pads if this is not the problem.
There will be a wire running to a sensor at the front wheel bearings on both sides. No wire to the bearing, no front abs.
There will be one on the top of the rear axle. There could also be one at each front wheel bearing.
Depending on 2 wheel abs or 4 wheel abs. there is one on the rear axle diferential housing and one on each front wheel bearing
Rear only system, top of rear axle. Four wheel ABS system, top of rear axle, and at each front wheel bearing.
All have a speed sensor on the top of the rear axle. If four wheel abs it will also have a sensor at each front wheel bearing.
You will need to remove the tire and wheel. Remove the axle end cap. Remove the wheel bearing seal. Remove the wheel bearing. Reverse the process to install the new will bearing.
Rear wheel abs was standard. Four wheel was an option. Look for a wheel speed sensor wire going to the passenger side front wheel bearing. If it is there, you have four wheel abs.
The front wheel bearings are a sealed bearing. You will have to remove the hub from the spindle, remove the lock ring (aka C clip), and press out the bearing. Installation is in reverse order but with a new bearing. YOU WILL NEED A SHOP PRESS TO REMOVE THE BEARING AND THE BEARING RACES.