To replace turn signal control module requires removing steering wheel. Took mine to a dealer - $245 out the door. Brake lights work great now.
in mark 8's they use a controler to make flashers flash. this module has gone bad
All Bulbs were replaced. fuses all checked, relay switch new and flasher, Also when the relay switch is in it gets really hot. Any suggestions
GO AND BUY I NEW light bulb !
Assuming you checked all the bulbs and fuses, it sounds like the signal switch is shot.
Blinkers, Reverses lights and Hazards are all wired into the same fuse. When a short occurs in one of the components all of the lights will cease to function. The fuse should be checked to see if they are in working condition.
You should have your rotors checked and possibly turned or replaced as necessary You should have your rotors checked and possibly turned or replaced as necessary
has anyone checked the fuses and bulbs?
The timing or crankcase sensor needs to be checked and most likely replaced.
Spark plugs, distributor cap, and distributor rotor should be replaced. Ignition coil should be checked for corrosion at the post. Clean or replace as needed. Spark plug wires should be inspected for corrosion. Clean or replace as needed. PCV valve should be cleaned. Fuel filter should be relaced. Air filter should be inspected and replaced if needed. Oil and filter should be changed if applicable.
it might be the hazard switch all the blinker circuit runs through it.
check fuses under dash panel and for short if wired for trailer
If you already checked your bulbs then check your fuses, usually this is the case when all the lights stop working at the same time.