Key on engine off press the gas pedal to the floor 3 times within 5 seconds Itll be reset when it stops flashing
press to release. says so right on the pedal.
press the pedal down as far as you can and as it goes up...it should release it...
When You Drive A Old Skool Car With A Carb You press down the pedal for cold starts but when car is warmed up you don't always have to press down the pedal Sometimes you need to press it down in the morning becoause of the condensation. //////on a car with a carburetor you need to press the gas pedal when starting cold to engage the choke and also the fast idle cam
the light surges because of the 12 second delay amperage solenoid.
all cars with abs breaks do this!! but if you feel it in the pedal then you have bad front rotors!!
maybe fuel filter or coil throttle/pedal pressure sensor according to my obd2 test kit for my '99. Try hooking up an obd1 and see what the diagnosis is.
98 Chevy cavalierIt might be a stick shift
On the factory radio you tune to the channel you want and press and hold the number you want it programmed on (1-6)
Put the key in to the "run" position (its just before you turn on your vehicle) Press gas pedal 3 times within 5 seconds the change oil & oil life will blink wait 10 seconds and turn on you vehicle if it doesn't reset repeat steps.
Occasionally the gas pedal will have some resistance when you press it. You could check and lube gas pedal, gas cable, and throttle itself.
The power brakes on most vehicles operate on the engine vacuum. If there is a leak or problems with the power brakes it can make a hissing sound. But then, sometimes power brakes do that when they're working properly. It could be from either a hole in the diaphragm of the brake booster or normal operation. If the sound is new, and was not there before, and your brake pedal is going to the floor, then you should have the power booster replaced.