Open the trunk, on the lip is a Phillips head screw, remove it.In the trunk to the far outside on the aft wall of the trunk are the 2 cargo net anchors, remove them and shake twist pull the entire fixture out.There are 4 light fittings. Each lamp holder is held in place with a spring clip that has to be depressed to allow turning the holder counter clockwise a quarter turn. Twist and pull, it will likely be difficult to get the lamp out. There is not a lot of slack in the wiring harness at this point. Remove the burned out lamp. It is very possible the lamp will separate from the bayonet base at this time. Use needle nose pliers to get the base out of the holder. Wipe some lamp grease on the holder before installing the new lamp. Reinstall the holder to the fixture making sure the spring lock clicks. Return the fixture to the vehicle reinstall the two anchor bolts and the Phillips head screw.I would recommend changing all 4 lamps at this time to save opening it up again and cleaning the dust and crud from around the fixture. The lamps are not all the same, check the bulb numbers at the parts store.AFM
you can take the tail light out by unscrewing the wing nuts in the trunk, when all wing nuts are off pull the tail light out then take the light bulbs out to replace the tail light.
No.... You need to change the whole back tail piece
Replace the whole light assembly Their are no bulbs it is neon light
Through the inside of the bed.
you don't replace the tail light you just replace the bulb in it
Remove the tail light from the outside. Pulls out. Replace bulb. There is no access from the inside of the trunk.
Remove the bolts !
On a 2012 toyota Highlander, How do you replace tail light Assembly
Remove tail light housing. Remove lamp. Replace lamp. Replace tail light housing.
You can not, you will have to replace the entire tail light.
I'm pretty sure it will.
How do you replace a broken tail light cover for a 2005 Nissan Pathfinder ?