Ball Joint Replacement: I used the rental tool to press out the old ball joint and press in the new one. When pressing out the old ball joint the key is to properly set up the press, tighten the screw on the press, then give the screw a few good solid blows to shock the old ball joint. Once I did this the old ball joint pressed out almost effortlessly. Installation of the new ball joint was a breeze. The only comment is be extremely careful not to damage the axle boot seals. Have wire on hand to tie the spindle assembly and axle for support to prevent damage to the brake hoses and ABS system.
The gross vehicle weight specifications for a 1985 Ford F1 50 pickup truck is 4140 pounds. The weight is the pickup truck without any fluids.
The only way to reset the sensor light on a 1985 Nissan pickup truck is to disconnect the sensor wiring. After 60 seconds, put the wiring back in place.
where is the fuel pump relay located on a 1985 Nissan truck
look by passenger tire by oil filter
25mpg
1985 Ford Bronco
Yes
is the fuel pump located in the gas tank
1324
I have a 1985 dodge pickup with a 225 slant six and a 3 speed overdrive transmission how do i adjust the clutch.
I need a diagram of the fuse box panel in a 1985 Chevy s10 pickup. Thank you.
check clutch slave cylinder