1. Wing - the wing generated the most lift to lift the plane into the air.
2. Horizontal stablizer - The horizontal stablizer is basiclly the set of mini wings at the end of the plane. It controles the elevator.
3. vertical stablizer - the vertical stablizer is a little piece near the horizontal stablizer. iIt is used to control the rudder so the airplane won't swing from left to right.
4. the rudder - is attached to the vertical satblizer and is used to move the atil left to right.
5. elevator - the elevator is attched to the horizontal stablizer and is used to move the plane up and down.
6. aileron - the aileron is a part of the wing and is used to help the wing roll from side to side
7. spoilers - the spoliers decrease the force of lift so the plane doesn't go to high.
8. flaps - on take off and landing they are used to increase the force so the plane will land smoothly and take off smoothly.
The main parts of the plane are nose, body, tail and wing.
go read the book and find out!!!!
The wing is the main flying surface. Control surfaces include the ailerons, flaps and slats.
go read the book and find out!!!!
What wing design for a paper airplane will soar the farthest
1905 was the first fixed wing airplane
The best wing shape for sn airplane is like a triangle because it fly straight
Yes because an airplane wing has to cut through wind and create loft and lift.
The air above an airplane wing in flight is at lower pressure than the air below the wing. Hope this helps.
It's the length of the wing. Depends on make.
No.
Monoplane