To replace the clutch cable on a 1989 Mitsubishi Triton from the foot pedal to the motor you need to secure the vehicle with blocks behind all of the tires. Next, you will need to life up the frame to give you enough room to get under the vehicle safely. Remove the clutch cable from the motor first and follow it up to the foot pedal. Remove the cable from the foot pedal area and then attach the new cable.
i belive the clutch adjusts automatically as its hydrolic not cable operated The clutch itself adjusts automatically, yes. However, you can adjust the pedal if your clutch is not engaging at the correct point as you press and release the pedal. Simply sit upside down in the seat (this is not as awkward as it sounds) and look at the rod that goes through the firewall connected to the clutch pedal. It will have a little nut on it that you can adjust with a wrench. That nut can work itself lose and make you feel like you have a failing clutch when really it's just the pedal.
The clutch pedal cannot be adjusted
It sounds like it is the clutch cable. I have a 94 Nissan Sentra and the clutch cable just broke. I have replaced one on an older Nissan, but it is still difficult for me to do on the 94. It is really hard to get the broken cable out.
The clutch pedal has an assist spring and return spring. The assist spring tension must be adjusted to create a balance point at which the clutch pedal will over center and return to the fully disengaged position. It is also possible that the system may have air or the push rod attached to the pedal may be out of adjustment.
The clutch pedal.
To adjust the clutch pedal height in the Peugeot 307 locate the adjuster bolt on the floor under the clutch pedal. Loosen the bolt and pull out the pedal to the proper height then tighten the bolt. To make the clutch pedal lower for the operator simply push in on the clutch pedal while the adjuster bolt is loose, then tighten the bolt.
The clutch pedal usually squeaks where the clutch pedal is mounted under the dash. The clutch pedal pivots at its mounting point so it probaly just needs some lubed sprayed on it.
A 1995 Honda Accord clutch pedal switch is located directly under the clutch pedal. This switch stops the car from starting with depressing the clutch. This helps avoid accidents.
the clutch on a 2000 ford f250 is a hydraulic clutch there is no adjustment however check the bushing on the rod and pin on the clutch pedal this bushing wears out and you loose pedal if the pin is wrn ,you will have to replace the clutch pedal
1. Air in the hydrulic clutch line 2. Bent aluminum clutch pedal
The clutch pedal pivots at the top, Unlike the gas pedal where the pivot point is at the middle.