number of things can cause turn tstat from auto to on to rule out power to unit, transfomer and motor if it dosent u have voltage problem or bad capacitor or fan motor
You may want to try askarepairtech.com. They can diagnose the problem by phone and if you are handy, you can replace the part yourself. If not, they can do it.
No it is not advisable. Put it on AUTO. The furnace will decide when it is practical to turn the fan on. Really. No it is not advisable. Put it on AUTO. The furnace will decide when it is practical to turn the fan on. Really.
turn off power to furnace and remove the bottom door to the blower compartment,the filter should be on the right side of the blower housing or it may be directly below the blower housing on the bottom of the furnace depending on how your return duct is run. hope this helps,FYI filters s/b replaced or cleaned every 30 days.
sounds like problem with tstat programming.
Watts
Yes it is. It contains the blower.
no
Have you checked the fuse and relay? - They are in the engine compartment above the passenger strut.
To add the sae 10 non detergent oil to your furnace blower motor you will have to open the motor section.
Yes, It`s on the inside of the blower compartment cover panel.
Furnace blower motors are easily found at HVAC installers and repair centers. However, without proper knowledge, a customer should not try to fix this, it can be dangerous.
It could have any size heating furnace, the two are unrelated except for the size blower used in the furnace to support the 3 ton cooling system. But the fact remains you can get a 3 ton blower in 50,000 btu furnace, a 100,00 btu furnace and anything in between.
A fan or cooler relay is used in electrical furnace to change the blower speed to the blank speed for cooling