Want this question answered?
The ignition timing marks can be found on the main pulley. The timing marks will be scattered on the outside edge of the pulley.
No need for timing marks on the outside of the engine that has no adjustable ignition timing.(DIS)
the cam gear mark is set at 6 o' clock and the crank gear mark is set at 12 o'clock.
Timing marks are generally found on the flywheel or crankshaft pulley. This indicator is used to set the timing of an engine's ignition system.
The D16 ignition timing needs to be set to the middle of the three marks. Typically, these marks are red and are located before the TDC mark on the crank.
Were are the timing marks on a 1991 acura legend
You dont.
It has no timing marks because the ignition timing is set by the computer and isn't adjustable.
tdc 12 degrees
there are two kinds of timing marks. one is for ignition timing and one for valve timing.
By diagram, if you are refering to the Emissions Control label located on the under side of the hood, it is only good for telling you what your timing (x degrees before top dead center (BTDC)) should be, given the engine you have. Haynes sells a service manual (about $17.00) that does a pretty good job of explaining how to go about setting the ignition timing on your engine, including descriptions of where the timing marks are for your engine and how to perform the timing adjustments.
1972 Plymouth duster strait 6 firing order