answersLogoWhite

0


Best Answer

36.4 psi

User Avatar

Wiki User

11y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: What is the fuel pressure in a 1976 Datsun 280Z?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Where is the fuel sensor for a 1976 Nissan Datsun 280Z 2.8L FI 6cyl?

Inside the gas tank.


Where is a fuel pump located on a 1976 Datsun 280z?

The fuel pump is located next to the tank behind the right rear tire.


What should fuel pressure be on a 1978 Datsun 280z?

I'm pretty sure it should be around 36 psi.


1978 Datsun 280z looses fuel pressure when it sits for awhile?

fuel filter may need to be replaced or the fuel pump is going out. check all of the fuel lines for moisture. wooden clothes pins work best for checking the lines


Where is the fuel pump relay located in a 1977 Datsun 280z?

I own a 1977 280Z automatic and the fuel pump relay is located above the kick panel on the right passenger's side floor in front of the door. You have to access it from under the dash.


How many volts does a fuel pump for a 1980 Datsun 280z need to work?

Assuming the car's electrical system is 12 volts, the answer is 12 volts??


What direction does the arrow on the fuel filter point on a 1979 Datsun 280z?

The outlet. Most fuel filters are built so that the hermetically sealed end is the OUTPUT. The rounded end is the INPUT.


Where is the fuel pump relay on a 1977 Datsun 280z?

I have a 74 260z and it's next to the passenger's right foot, just in front of the door. Hope that helps!


Where is the fuel pump relay located on a 1976 Nissan 280z?

Under the dash on the passenger side behink the glove box. It is under the dash on the driver side in my 1977 280z


Not getting power to fuel pump on 1976 Datsun 280zx?

Good! Save gas!


What would cause a 1977 Datsun 280z to run to rich and flood out?

temp sensor going bad will cause the engine to dump fuel and foul plugs very quickly.


What are the Fuel Pressure Secifications for a 1981 Datsun 280 zx?

30-37 PSI if it is non-turbo