Glue and Glass I'd say both Glue helps things when u need to put things together and it is really good for projects and also to fix broken things. Glass can help u drink beverages and it helps u see better thats what glasses were made for. Sometime a days when u are blind and u look through a glass u could see better because glasses and glass are the same but don't try to get blind and look through a glass it can cause really bad things for ur eyes.
I use Mapei vinyl adhesives. There are a few choices in the stores, depending on the wall surface. Look in Home Depot for a good selection .
A vinyl tile glue will do that -Mapei Ecobond, in Home Depot.
It depends on the type of ceramic adhesive. Many of them can be taken off tile with lacquer thinner on a rag.
Epoxy or silicone.
yes
if it is glazed ceramic tile - let it dry fully (I let mine dry for a few weeks) then CAREFULLY pop the glue off with a chisel. Hold the chisel so the flat end is up and the beveled end is on the tile and gently push the tip of the chisel into the (expanded) gorilla glue. hit the end of the chisel with the palm of your hand and the glue will pop off the ceramic.
It is best to remove the vinyl tile. If it is not on cement and is on wood you can install cement backer board. Be sure to put thin set under the board. If you spend the money and time to install ceramic tile and the vinyl tile comes loose all that $ is down the drain What is the best tile cement to use and this cement tile can be installed on vinyl tile and install ceramic tile on it
Any epoxy or LePage Extreme or PL200 would work for that.
Yes you can if you first rough up the ceramic by sanding it. Use a vinyl mastic like Mapei Unibond.
Yes, soften it with Goof Off, then scrape it with a craft knife, blade almost parallel with tile.
Not directly as the ceramic tiles will soon show through the vinyl flooring. If the ceramics are laid on a wooden floor, you must take up the tiles and overboard with 6mm plywood. If the tiles are on a concrete floor, you can leave them down and lay a latex screed on top to provide you with a smooth floor for your vinyl
I would use PL300 or a similar general adhesive.
form_title= Ceramic Tile form_header= Install ceramic tile in your home! Where would you like the ceramic tile installed?*= _ [50] Do you need the ceramic tile to be custom cut?*= () Yes () No () Not Sure What type of tile do you what installed?*= _ [50]