Trouble code P1311 means: ION Sensing Module Secondary Line 1 Circuit Malfunction Honda Man's Answer I installed a used engine in a 2002 Isuzu Axiom and ended up with a random misfire code (P0300) and a P1311. Some of the causes of a P1311 on this model can be; # Timing off - was a timing belt just installed? # Incorrect spark plugs - if anything other than Denso spark plugs are used, a P1311 can be triggered. # And finally the cause of the code in my situation was the rear Oxygen sensor electrical plugs were switched. The harness that goes on-top of the transmission includes O-2 sensor wiring with enough length and the same plugs that allows them to be easily mixed up when transmission or engine has been out for service.
Not a valid code number, check again. If it's P0131 then it would be a oxygen sensor on bank 1 sensor 1, low voltage.
Can show vacuum leak as a trouble code. Can show vacuum leak as a trouble code.
Perhaps disconnecting batt for 30 mins-but it will just come back on.
You'll need a ODBII code reader to reset the check engine. The connection is under the stearing colonm. First check the code, clear the problem and the reset the light.
www.canobd2.com got to this web site put in Ford and also trouble code and it will tell u what it is
The code P1000 in Isuzu is not a permanent code but a fault code.
the code is 756235
Don't get a pos Isuzu Rodeo
i cant find the color code for my 1995 Isuzu trooper CD cassett please help
A fault code 081 on a Isuzu Bighorn means that the car starter is not working properly. You should replace the starter and the code will go away.
it is low coolant temperature, could be the thermostat could be the sensor for coolant temperature.
Trouble code P0730 means:Incorrect gear ratio