0
Add your answer:
Earn +20 pts
Does all romex have a ground wire?
Some older wire does not have a ground. All you can do in that case is use a jumper wire to connect the ground to the neutral.
Why no electric shock from neutral line?
There is normally no voltage on the neutral line because the neutral line is grounded. However, and this is always important, do not assume that neutral is grounded, nor that there is not an elevated voltage on neutral or ground due to a possible ground fault.
Does a toaster use a neutral phase?
There is no such thing as a 'neutral phase'. 'Live' or 'hot' conductors are called 'lines', whereas the neutralconductor is at approximately earth (ground) potential.So, a toaster would be connected between a line and a neutral conductor.
What is meant by neutral grounding reactor?
Neutral-earthing reactors or Neutral grounding reactors are connected between the neutral of a power system and earth to limit the line-to-earth current to a desired value under system earth fault conditions.
How do I rewire an ungrounded plug?
If there is no ground wire connect the ground wire to the neutral wire.
Does all romex have a ground wire?
Some older wire does not have a ground. All you can do in that case is use a jumper wire to connect the ground to the neutral.
Can you use ohm-meter to measure a resistance between the neutral line N and the ground E?
If the meter is sensitive enough and there is a resistance between the neutral and ground then the meter should be able to detect it.
Can you use the earth wire between room stat and honeywell board as a neutral?
ABSOLUTELY NOT!The protective earth ground wire is only there to provide a low resistance path to ground in the event of a short circuit so as to trip the protective device. Operational current is never, under any circumstances allowed to be passed on earth ground. Use neutral for neutral and ground for ground.CONSULT A QUALIFIED AND LICENSED ELECTRICIAN !!!!
Why you use neutral pin in three pin plug?
In North America the neutral pin is used to complete the circuit. One pin is "hot", one pin is neutral and the last pin is ground.
Is it advisable to use line to neutral power supply on a single phase residential area when the safety is concern?
line to line or line to neutral is the only way to use power line to ground if a FAULT current in the ground is a problem that needs to be corrected, an insulation fault
Difference between ground and neutral?
As i know,neutral is the return path of current & ground is for any leakage current
How can you tell if the ground wire is approriately bonded to the neutral and the cabinet at the service box?
To check if the ground wire is properly bonded to the neutral and the cabinet at the service box, you can use a multimeter to test for continuity between the ground wire, the neutral wire, and the metal cabinet of the service box. If there is continuity between all three, then the bonding is appropriate. It is important to ensure that this bonding is done correctly to provide a safe electrical system.
Can a green wire be used for a neutral?
'Can' yes. 'Should' no. <<>> Never use a green wire for a neutral. It is colour coded for a reason and that is to protect the people that work on electrical equipment. If you turn a ground wire into a neutral it then becomes a current carrying conductor. There are times in the electrical trade when grounds have to be disconnected and if it is used as a neutral and the tradesman is holding one end and touching a grounded object a shock will occur. Again never use a green ground wire as a neutral.
Why does your panel have a neutral but no ground?
Just checked and it does have a ground connection.
What two colors may be used for the ground conductor neutral?
What two colors may be used for the ground conductor (neutral)
Why no electric shock from neutral line?
There is normally no voltage on the neutral line because the neutral line is grounded. However, and this is always important, do not assume that neutral is grounded, nor that there is not an elevated voltage on neutral or ground due to a possible ground fault.
When wiring a range the outlet has a neutral ground and 2 hots you have three wires do you put the bare wire in the neutral or ground on the outlet?
the bare copper is always a ground
