answersLogoWhite

0


Best Answer

Compression fittings are used to join two tubes or pipes together. Typically it is used when the two pipes are different materials or different sizes. They are also sometimes used on pipes where it is difficult to solder or maybe dangerous to do so.

User Avatar

Wiki User

11y ago
This answer is:
User Avatar
More answers
User Avatar

Wiki User

13y ago

A compression fitting fits over the end of a non-threaded pipe or piece of conduit. As a rule, they are not made for any application that includes high pressures, either gas or liquid.

This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: What are compression fittings used for?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Can compression fittings be used on hard copper?

Yes, the compression fittings designed for copper work on both soft and hard copper pipes.


Can you over tighten compression fittings?

yes


Should Teflon tape be used on compression fittings?

Pipe dope better solution than tape.


Flare-less compression joints for piping?

Yes they have compression joint fittings for copper.


Should i use copper or compression fitting on rigid copper?

If you are joining rigid copper pipes together, it is recommended to use soldered copper fittings instead of compression fittings. Soldered fittings provide a more secure and leak-free connection compared to compression fittings, especially under high temperatures and pressure.


Can compression fittings be used for gas piping?

It depends on the laws of your state or country. I would say, to be safe, inspect the gas line and install the same type of fittings you find there.


Do you use pipe dope on compression ring fittings?

no


How do you install rolled copper plumbing?

Unroll it and use as you would normal hard copper. Compression fittings or soldered fittings.


Can you use compression fittings on natural gas pipes?

No. You can use flared fittings with a flaring tool and soft copper pipe.


Can you use standard compression fittings or must you use flared fittings when you need to join two lengths of copper tubing for use with a kerosene fueled monitor heater?

I believe it has to be flared as compression is not approved


What do you use to seal black PVC 1 inch with?

The correct compression fittings.


Is it safe enough compressiom fitting in rediator pipe?

No. Compression fittings are NOT for steam pipes