0
Add your answer:
Earn +20 pts
What ports are used by dhcp and the DHCP client?
The port 67 and port 68 are used by DHCP and the DHCP clients.
What TCPIP model layer does DHCP work at?
DHCP is a layer-4 protocol, most commonly transported over UDP. UDP port number 67 is the destination port of a server, and UDP port number 68 is used by the client
What is the dns port number and dhcp port number?
DHCP listens for incoming on UDP 67 and send out on UDP 68 For 'well known' and 'registered' ports, you can check http://www.iana.org/assignments/port-numbers too. by gerson.freire@terra.com.br
What protocol automates assignments of IP address on a network?
DHCP and port 68 conquerorthecomputer.blogspot.com
How are bootp and dhcp related?
they both run on the same port number
Which protocol allows for the automatic configuration of host tcp ip address?
There are two ways to configure Ip address . One method is to do this manually .And other is to do this using dynamic host configuration protocol.
What Automates assignment of IP address on a network?
DHCP and port 68 conquerorthecomputer.blogspot.com
Why does your computer doesnot acccept any ip address?
You need to make sure that your network adapter is configured to receive IP address automatically from DHCP server. Second make sure that your firewall allows incoming connections for DHCP port (usually port 61). And third make sure that the DHCP server is "allowed" to give your adapter an IP.
What step is this dhcp discovery dhcp offer dhcp request dhcp acknowledge?
Those are the four phases of acquiring an IP address via DHCP. More information would be needed to indicate which of the 4 phases are being used at this point.
Is it possible to connect a LAN and WAN?
The steps for doing this areConnect N600 LAN port to 7700N LAN portDisable DHCP on N600Enable DHCP on 7700NManually give the N600 an ip in the 192.168.1.x range (outside the DHCP range)This will then put all devices in 192.168.1.x range, and be far simpler.
What tool is used to configure a DHCP scope?
For a Windows based system you use the DHCP MMC snapin console. This is installed when the DHCP server service is installed. For Linux and Unix based systems you can edit the DHCP configuration file in /etc
What is the minimum action you need to take to receive DHCP assigned address?
Your network adapter must configured to receive IP address from DHCP server (default in Windows), also your firewall must allow connection to the port 67.
