answersLogoWhite

0


Best Answer

Duck tape should do the trick

User Avatar

Wiki User

16y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: How to replace trunk lid support on 1998 Mercury mystique?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Can you fold down the rear seat of a 2000 Mercury Mystique if it was not equiped with a pull lever?

check in the trunk right below the speakers there might be a lever there my 1996 model that's where they where


Where is the Evap vent solenoid on a 2000 Mercury Mystique?

check under the truck, under the car behind the fuel tank, it's on the evap tank, take off the black cover under the trunk,


Replace 1997 Mercury Grand Marquis tail lamp bulb?

Look inside the trunk. Have to remove the wing nuts.


How do i replace a brake light in a 1997 mercury grand marquis?

Remove the wing nuts from inside the trunk, the assembly will pop out.


Where could you find a socket for the back up light on a 99 mercury mystique?

I believe that the light bulbs are located in the trunk lid and are basic 1156 bulbs but they fit into a bulb holder that fits into the housing with a twist and turn motion.


How do you replace the lock on the trunk?

how do i replace a trunk lock with another lock that has a key


How do you remove and replace the tail light assembly on a 2006 mercury montego with out damaging the trunk felt lining etc?

if you carefully pull on the liner it will fold down.


Where is the module located on a 1993 Mercury Cougar?

In the trunk


Where is the fuel switch for a 2002 Mercury mountaineer?

in the trunk


How do you replace the rear speakers in 2006 Pontiac G6?

go into the trunk and disconnect the wires and then pull the speakers out from the trunk and replace.


Where is the inertia switch located on a 2003 Mercury Sable?

On a 2003 Mercury Sable sedan : The fuel pump inertia switch ( shut off switch ) is in the trunk , on the passenger side of the trunk , behind the trunk liner ( there is an access hole )


How could you use mercury to make a switch to turn on a light when the trunk of a car is open?

You do not need mercury. Just install a door jam switch in the trunk wired into a light in the cat so that when the trunk is open a light will come on in the vehicle.