answersLogoWhite

0


Best Answer

If you have the controls on your steering wheel than all you have to do is push the button with the little gas pump logo on it until engine oil life and the % come up on the little screen, then hold down the arrow button (lower right) for 5 or so seconds and it will say oil life reset and it will go back to 100% and it wont ding at you anymore.

Another method:

To reset the CHANGE ENGINE OIL message, turn the ignition key to RUN with the engine off. Fully press and release the accelerator pedal three times within five seconds. If the CHANGE ENGINE OIL message flashes for five seconds, the system is reset.

User Avatar

Wiki User

10y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: How do you reset the check engine oil light on a Chevy Silverado?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

How do you reset the check engine light on a 2006 Chevy Silverado 1500?

That REQUIRES an ENGINE SCANNER to do that.


Can you drive your truck 2003 Chevy Silverado with the check engine light on?

Yes but, if the light is flashing no.


What are the codes to a Chevy silverado 4x4 1500 1992 check engine light?

See link below.


What is cause the check engine light to come on in a 2005 Chevy Silverado?

It might be that you did not tighten the gas cap enough.


What does it mean if your engine runs but the check engine light comes on a 2002 Chevy silverado?

It is on because the ECU has detected a problem with the emissions system.


How do you reset the check engine soon light on a 2002 Chevy silverado?

You use a scan tool after repairing the cause of the code that turned the light on.


Where would you fine check engine light codes for a Chevy silverado truck?

You can buy the check engine computer and the book comes with it. I know, I bought one. When your check engine light comes on, you plug it in and check the engine and it will give you the code and you look in the book for that code and it gives you the answer.


Can your 1999 Chevy silverado run without catalystic conveter?

It will run, But not right and the check engine light will come on. It needs the converter.


Your 2008 Chevy silverado truck engine light stays on?

no it doesnt


How can i troubleshoot a check engine light on a 2002 Chevy silverado?

you need an obdII scanner to read codes. either that or one of the many after market programmers.


What if service engine light is blinking on a Chevy silverado?

Normally a flashing check engine light means you have a misfire. Do not ignore this as an engine misfire will damage the O2 sensor and the catalytic converter which are very expensive to replace. Have this repaired immediately.


How do you reset check engine light for the 2009 Chevy trail blazer?

How do you reset check engine light for the 2009 Chevy trail blazer?