I assume this is a manual crank window, not power windows. If the hand crank just spins around without raising the window all the way, the regulator inside the door is stripped. You'll need to remove the outer door panel to get to it, and a drill to drill out the rivets that hold the regulator in (and rivets or bolts to install the next one). Best to get a manual that covers that. Also, get a "new" one that works from a junkyard, and removing it will show you how to get the sucker out. Good luck.
:-) teeny
----------------------
The drivers side electric motor is the first one to wear out (the most used). A replacement motor can be bought for about $100. Take the door cover off and you will see 3 rivets holding the motor. Carefully drill these out, remove and replace the motor. I have replaced 3 of these -2 drivers, 1 passenger. On one I used 3 bolts/nuts to hold the motor in place.
Arnie
how to repair drivers side manual window for 2002 jeep liberty sport
get a new window switch
check the fuses
The 1998 VW Jetta drivers side power window relay switch can be found inside of the drivers side door. You will need to remove the drivers side door panel in order to access the power window relay switch.
cANNOT GET THE DRIVERS SIDE WINDOW UP, IT IS PARTWAY DOWN AND HAVE TRIED SPRAYING CLEANER IN IT, NO GO. WHAT DO I DO? The switch, or relay, for that window is faulty, or worn out (since drivers window is most used). Replace it.
Buy a new window switch part #5L1Z14529AA easy fix!.. It's a very common problem the drivers window sticks when going up
no they can be on drivers side window
could be that also could be the window moter or just wiring
You can find the window relay switch inside of the drivers side door. You will need to remove the drivers side door panel in order to access the window relay switch.
Remove the 2002 Ford Explorer drivers side inside door panel. The entire window mechanism will be visible. Locate and repair the cause for the window malfunction.
Remove the 1997 Chevrolet Suburban drivers side door panel. The window mechanism will be visible. Place the new window into the window track. Secure the window to the track.
You will need to raise the drivers side window all the way up and then hold the button in the up position for about 20 seconds, that should do it.