It seems there are more than one type of cable for the 206 series. My experience is with the auto-adjusting type - the cable cover stretches to avoid being loose. The tricky part is the the connection to the pedal. First release the gear box end of the cable ... very simple, just force the gear box lever towards the cable and pull the large disc-shaped end of cable (1) out of the lever slot (no screws, no locks). Then release the other disc-shaped rubber terminator, also, just pull it out (no screws or locks). Now go inside the car and loose the screw that holds the clucth pedal assembly. Pull it down so you can see the cable terminator into the small plastic lever (the "bielete") behind the pedal ... pull the connector in the reverse direction of the cable and it will come out ... now just release the front end connector ... again just pull it towards the engine, a little angle, ad it will come out ... easy after you spent some hours discovering how to do it. Good luck.
1 2 3 4
-------=================---o
1- gear box lever terminator/connector
2- intermediate rubber connector
3- front end terminator
4- pedal terminator
no
A
yes
How to fit clutch cable on a daewoo cielo
Very simple answer, yes
yes the kit will fit a 206 gti, the outside (shell) are the same the difference is in engine and interior mods the kit will fit !
no
Toyota
No you, need to have a turbo in order to fit a dump valve
its hydraulic not cable
how to remove and fit rear brake shoes on a peugeot 206 1.1
Only if you modify the car