Find bleeder screw (looks like a grease fitting) on upper end of wheel cylinder or caliper "Free" this up to loosen they have a tendency to "freeze" due to age. Attach a piece of tubing to this fitting submerge other end of tubing into a container partially filled with brake fluid Have assistant pump and hold brake pedal Loosen bleeder screw and allow brake pedal to drop to about 2/3 of its travel range Observe hose submerged in brake fluid Continue this process (probably 3-4 times) until no air bubbles are observed in container that hose is submerged in. Tighten fitting securely
brake light on dash blinking
The bleed screw on the calipers of brake systems are for 'bleeding' air out of the brake lines.
The 1998 Nissan brake light switch is located below the dashboard, on the drivers side of the engine compartment. The brake light switch simply plugs in and out.
Replace or check adjustment or alignment Usually located at the upper end of the brake pedal under dash area
Check with a Nissan dealer.
where is the starter located on a 1998 Nissan sentra
why after changing my front brakes on my Nissan altima,my brakes peddle got really soft YOU FORGOT TO BLEED YOUR BREAK LINES~! GO TO AUTOZONE, OR PEPBOYS OR ADVANCED AUTOPARTS AND GET A BRAKE BLEEDER KIT..THEY ARENT EXPENSIVE AND ALLOW YOU TO BLEED YOUR BRAKE SYSTEM ON YOUR OWN.
OBD2
Yes, but with improvements along the way. Better camshafts etc...
The shifter linkage might be jammed or disconnected. The shifting sensor, that detects if the brake is engaged, may be malfunctioning.
To remove a 1998 Nissan Sentra Transmission, you first need to locate all of the bolts. From there, you will remove the bolts. Undo any wiring or tubing that goes into the transmission. From there, it can be taken out.
I have no idea to bad huh PEaCE