2000 sonata rear seat removal
Photos of tabs to remove
The lumbar components are located inside of the back of the seat. You will need to remove the seat, then take the back cover off to see what is wrong with the lumbar support an repair it.
how do you replace seatbelt retractor on a 2000 chevy blazer
The seat belt might not fasten in a 2000 Chevy Blazer because there is a foreign object in the slot where the seat belt fits. Even the tiniest of objects can cause the seat belt to not latch properly.
Below the seat at floor level, there are two bolts hidden under the edge of the seat. Once you remove them, the seat simply lifts out. Then removing the seat belt bolts and pulling up on the back rest removes it...
Push very hard at the center of each back seat (left and right seat) towards the back of the car. Then, while pushing back, lift up. It will pop out of its catch.
It's under the back seat. Pull up on the front edge of the back seat to remove it.
Your battery is located under you back seat. You have to remove the bottom section of your back seat before you can change it. After you remove the seat if you take it to a local automotive store and purchase a battery, they usually will change them for free.
there are two bolts in the back of the seat. remove them and then slide the seat back about an inch and remove
In my 2000 LeSabre, it's under the back seat. Remove the rear seat and I'll bet it's there.
I have a 2000 Honda VT1100 Shadow Spirit. I am not sure the 750's or later models have the same setup, but it is a place to start. "REMOVAL" Remove the rear seat bolt. (It is located at the rear of the back seat at it's base; centered, and more or less straight down from the backrest. Remove the rear seat by pulling it up, back, and then up and forward. Remove the front seat bolts. (there are two, centered at the back base of the now exposed front seat). Remove the front seat by pulling up and back.