Yes, it screws out and has a simple connector. Look in a manual for the exact location of the sensor. In earlier models it was on the engine block, near the starter.
The knock sensor just advances and retards the engine timing only. If there is a noise in the engine then you have engine are valve train problems. The knock sensor will not make the engine knock.
Motor
the motor could pre-detonate or "knock" that can cause damage
A knock sensor detects engine knock in the motor(aka pinging, detonation, or uncontrolled explosions. it basically means the motor is about to blow up or potentially could.) the second part to a knock sensor is that it keeps the ignition timing as advanced as possible to make the most power without making engine knock. So if you have a bad knock sensor or have a check engine light form a knock sensor your car will be slower. this is when your car goes into LIMP mode which is basically a preset running condition which is safe for the motor.
Knock sensor is located in block below rt.[ pasasenger] side motor mount.
On the 5.4 the knock sensor is under the intake and the connector is in the back of the motor on the passenger side.
check the anti knock sensor on the side of the motor
The knock sensor is on the right side of the motor on the block .It runs under the manafold.I can not get the retaining clip off.MIKE
The knock sensor for the 1993 Chevy Cavalier is located in the back of the motor. It can also be located in the engine valve.
right front of motor
The knock sensor for a 3.5 Honda engine is located on top of the motor under the intake. It is about a 1.5 hour job to replace it.