0
Add your answer:
Earn +20 pts
What is a cable with terminators at each end and is shared all nodes?
Bus Cable
At the ends of each bus network are 50-ohm resistors known as?
terminators
What is A cable with terminators at each end and is shared by all nodes?
Bus Cable
A bus network would suffer from signal bounce without what?
a specific resistor/ capacitor circuit connected to a 555 timer will create a debounce switch in synchronous format
Why terminators are used in a bus topology?
So that the Signal will not reflact back due to difference of permitivity of signals that causes destructive interfrance... They are used in End of Bus topology
When are buses used in a computer?
Inside a computer, a bus transfers data between components. A bus is thought of as being the physical wires that make the connection, but these days the software that controls data transfer is also thought of as part of the bus.
WHAT IS A bus network?
Bus networks are usually based in a single room and look like such: _ _ _ Computers :-----------------: actual cable line and terminators (cables would goto the PCs) _ _ _ more PCs The medium is a coax cable (looks like tv cable) and requires terminators on both ends of the cable for stopping the resonence of the signal. All pcs are directly hooked into the coax cable and any break in the cable will result in complete network failure. Average speed was 10Mbps The computers required special network cards capable of hooking up to the coax cable, often refered to as a BNC connector.
What Is The Slowest Computer Bus?
The slowest computer bus would be a stopped or halted computer bus, since there would be infinite time between operations.
What does a computer bus used for?
A Computer Bus is usually the USB Ports, and there used for USB Plugging things.
What is bus on a Chrysler?
The "bus" is the communication system for the computer on the car.
What is Intel system bus called?
A Intel system bus is a single computer bus that connects the components of a major computer system. The system bus also referred to as crossbar switch.
Which network access method relies most often on a star-wired bus physical topology?
A star-wired bus is a hybrid topology (more than 1 type of topology). There is no particular access method that requires or relies on that type of hybrid.
