0
What else can I help you with?
Why set clock rate in router?
To configure the clock rate for the hardware connections on serial interfaces such as network interface modules (NIMs) and interface processors to an acceptable bit rate, use the clock rate interface configuration command. Use the no form of this command to remove the clock rate if you change the interface from a DCE to a DTE device. Using the no form of this command on a DCE interface sets the clock rate to the hardware-dependent default value.
The CardBus technology uses -bit PCI for the interface standard?
32-bit
Which is faster serial interface or parallel interface?
It depends on the serial bit rate versus the parallel strobe cycle time but, in general, a parallel interface is faster than a serial interface. However, modern USB, Firewire, and SATA interfaces are very fast, and might be considered faster.
Give an example of a signal for each what conditions the baud rate is equal to the bit rate the baud rate is greater than the bit rate and the baud rate is less than the bit rate?
Basically the baud rate can never be greater than the bit rate. Baud rate can only be equal or less than the bit rate. However, there are instances that baud rate maybe greater than the bit rate. In Return-to-zero or Manchester encoding, where there are two signaling elements, the baud rate is twice the bit rate and therefore requires more bandwidth.
What is bit rate of Ethernet when Manchester encoding is used?
bit rate is half the baud rate
What transfers one bit on data at time?
serial interface
1what type of interface connects a device to the system unit by transmitting data one bit at a time?
A serial port is an interface in which one bit of data is transmitted at a time.
What are the factor affecting rate of penetration?
Factors affecting rate of penetration in drilling operations include the type and condition of the drilling bit, the weight applied to the bit, the type and properties of the formation being drilled, the drilling fluid properties, and the drilling parameters such as rotary speed and drilling direction. Additionally, environmental factors like temperature and pressure can also influence the rate of penetration.
What is the future type of external memory?
If you mean after external hard drives, probably am 80 GB credit card. MSM9841 and MSM9842 offers two types of memory interface: interface when DMA controller is used (16-bit bus) that memory interface is through DMA controller; interface without DMA controller that memory interface (16-bit bus) is through CPU.
Difference between bit rate and bit period?
Bit rate is related to the maximum frequency being sent over a channel; it is roughly twice this maximum frequency. Bit period is the time it takes to send a bit; it is 2/(bit rate).
Which kind of interface transmits one bit at a time?
Serial interface transmits one bit at a time, typically using a single data line. Examples include USB, RS-232, and SPI interfaces.
What is difference between baud rate and frequency?
baud rate is the rate of symbol changes...symbol can be of 1 bit, 2 bit , 3 bit etc.... Where as frequency is the inverse of rate of lowest unit in a digital transimission...
