answersLogoWhite

0


Best Answer

The nut size of the Dodge RAM is 11/16th. This is mainly for the 12th point of the 1998 model of the 1500 from wheel.

User Avatar

Wiki User

βˆ™ 10y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: 1998 dodge ram 1500 front wheel bearing nut size?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

How do you change front axle bearing in 2002 dodge ram 1500?

Begin by removing the tire and wheel from your 2002 Dodge. Remove the end of the axle. Remove the wheel bearing nuts. Remove the wheel bearing. Reverse the process to install your new wheel bearing.


Does a 2002 dodge 1500 have a rear wheel bearing?

Yes.


When should you grease your front wheel bearings on a 2x2 1500 Ram Dodge?

The front bearings on Dodge Rams after 1998 are all sealed and non serviceable. If you have an older Ram with serviceable bearing, every 50000


What causes a grinding noise when only turning right in a 2003 dodge 1500?

More than likely you have a defective left front wheel bearing. Inspect the bearing and also inspect the bearing on the right front. Inspect your brake pads if this is not the problem.


How can you tell if you have anti lock brakes on the front of 2005 Dodge Ram 1500 pickup truck?

There will be a wire running to a sensor at the front wheel bearings on both sides. No wire to the bearing, no front abs.


Where are the wheel speed sensor's on a 2000 model dodge ram 1500 3.9L V6 with auto trans?

There will be one on the top of the rear axle. There could also be one at each front wheel bearing.


Where is the speed sensor located on a 2003 dodge ram 1500 quad cab?

Depending on 2 wheel abs or 4 wheel abs. there is one on the rear axle diferential housing and one on each front wheel bearing


Where is the location of the abs sensor on a 1994 dodge ram 1500?

Rear only system, top of rear axle. Four wheel ABS system, top of rear axle, and at each front wheel bearing.


Where are the antilock brake sensors on 1998 dodge ram 1500 5.2 ltr?

All have a speed sensor on the top of the rear axle. If four wheel abs it will also have a sensor at each front wheel bearing.


How do you replace a front wheel bearing on a 1992 Chevy silverado 1500?

You will need to remove the tire and wheel. Remove the axle end cap. Remove the wheel bearing seal. Remove the wheel bearing. Reverse the process to install the new will bearing.


Does 2005 dodge ram 1500 4wd have 4 wheel anti lock brakes?

Rear wheel abs was standard. Four wheel was an option. Look for a wheel speed sensor wire going to the passenger side front wheel bearing. If it is there, you have four wheel abs.


How do you change the front wheel bearings on a 2004 ram 1500?

The front wheel bearings are a sealed bearing. You will have to remove the hub from the spindle, remove the lock ring (aka C clip), and press out the bearing. Installation is in reverse order but with a new bearing. YOU WILL NEED A SHOP PRESS TO REMOVE THE BEARING AND THE BEARING RACES.